Hi guys,
I rooted my GS4 (SGH-I337 running 4.4.4) but wanted to update it but was receiving an error that said "install interrupted". I then used flashify to flash back to stock firmware that i downloaded from SamMobile. However, after I rebooted the phone, it became stuck on the ATT logo screen. I have tried to use Odin but I get a fail message. Here are the logs:
<OSM> I337UCUAMDL_I337ATTAMDL_I337UCUAMDL_HOME.tar.md5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/004> Odin engine v(ID:3.1005)..
<ID:0/004> File analysis..
<ID:0/004> SetupConnection..
<ID:0/004> Initialzation..
<ID:0/004> Get PIT for mapping..
<ID:0/004> Firmware update start..
<ID:0/004> SingleDownload.
<ID:0/004> aboot.mbn
<ID:0/004> NAND Write Start!!
<ID:0/004> FAIL! (Auth)
<ID:0/004>
<ID:0/004> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
Here is what the phone says on Odin Mode:
Product name: SGH-I337
Current Binary: Samsung Official
System Status: Custom
KNOX Kernel Lock: 0x0
KNOX Warranty VOID: 0x0
CSB-CONFIG-LSB: 0x30
Write Protection: Enable
emMMC Burst MODE enabled
START [224,1440]
SW REV. CHECK FAIL : FUSED : 5 Binary : 1
I have tried Odin v3.10.6, 3.09, 1.85, 3.07, and 3.04 with the same result. I read in some forums that using a pit file would help, but I receive a fail message using it saying, "Re-partition operation failed".
I have also tried wiping cache partition and factory reset through recovery mode with no success.
Any help would be appreciated, thanks in advance! :)
-Daniel
I rooted my GS4 (SGH-I337 running 4.4.4) but wanted to update it but was receiving an error that said "install interrupted". I then used flashify to flash back to stock firmware that i downloaded from SamMobile. However, after I rebooted the phone, it became stuck on the ATT logo screen. I have tried to use Odin but I get a fail message. Here are the logs:
<OSM> I337UCUAMDL_I337ATTAMDL_I337UCUAMDL_HOME.tar.md5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/004> Odin engine v(ID:3.1005)..
<ID:0/004> File analysis..
<ID:0/004> SetupConnection..
<ID:0/004> Initialzation..
<ID:0/004> Get PIT for mapping..
<ID:0/004> Firmware update start..
<ID:0/004> SingleDownload.
<ID:0/004> aboot.mbn
<ID:0/004> NAND Write Start!!
<ID:0/004> FAIL! (Auth)
<ID:0/004>
<ID:0/004> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
Here is what the phone says on Odin Mode:
Product name: SGH-I337
Current Binary: Samsung Official
System Status: Custom
KNOX Kernel Lock: 0x0
KNOX Warranty VOID: 0x0
CSB-CONFIG-LSB: 0x30
Write Protection: Enable
emMMC Burst MODE enabled
START [224,1440]
SW REV. CHECK FAIL : FUSED : 5 Binary : 1
I have tried Odin v3.10.6, 3.09, 1.85, 3.07, and 3.04 with the same result. I read in some forums that using a pit file would help, but I receive a fail message using it saying, "Re-partition operation failed".
I have also tried wiping cache partition and factory reset through recovery mode with no success.
Any help would be appreciated, thanks in advance! :)
-Daniel
from xda-developers http://ift.tt/1mRzmbP
via IFTTT
Aucun commentaire:
Enregistrer un commentaire